Asus AP130 Guida Utente Scaricare il pdf (Pagina 44)

Chapter 2: Hardware setup

2-28

SATA backplane jumper settings and HDD ID assignments

The 6-pin jumper J1 allows you to define your desired SATA configuration.

The picture below shows the location of jumper J1 with pins 1-3 and 2-4

shorted.

Refer to the table for the jumper

settings and the appropriate ID# for

each SATA HDD bay.

J1 setting

(1-3 shorted, 2-4 shorted)

Device SATA BP ID

Drive Bay 1 CON2

Drive Bay 2 CON4

Drive Bay 3 CON6

Drive Bay 4 CON8

• Put a jumper cap over pins 3-5 and 4-6 of the J1 jumper on the

second SATA backplane, if you installed one.

• Due to limited power supply, it is not recommended that you install

more than six hard disk drives on this system. If you wish to install

more than six hard disk drives, install a new power supply unit with

a higher power rating.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 65 66

Nessun commento

Asus AP130 Guida Utente Pagina 44