Asus AAM6000EV Specifiche Pagina 57
- Pagina / 69
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
<channel> qos [cbr|ubr] [pcr <pcr-tx> [<pcr-rx>]]
Description:
Specify that the VC for a PPP channel should be Constant Bit Rate or Unspecified Bit Rate, and (optionally for UBR)
give a Peak Cell Rate for the connection. If two values are specified then they are transmit and receive PCRs
respectively. If called while not attached to a VC then the settings are saved for use when a VC is created. If the channel
is already attached to a VC then it is closed, and re-opened with the new values. If it cannot be reopened, it remains
closed. Configuration saving saves this information. By default channels are established UBR.
Example:
> ppp 3 qos cbr pcr 10000 ;
set channel 3 to be CBR limited
at 10000 cells/sec
13.7.17. <channel> remoteip
Syntax:
<channel> remoteip [<ipaddress>]
Description:
If a PPP link is established using IPCP, this call causes the channel to provide the given IP address to the remote end of
the connection. PPP will refuse to complete the connection if the other end will not accept this. This is normally used for
channels on which the remote party dials in, to allocate the IP address to that remote party. Call with no argument to find
the current setting.
Call with 0.0.0.0 to remove any setting. This is the default state.
Configuration saving saves this information.
13.7.18. <channel> svc
Syntax:
<channel> svc listen [ip|mac]
<channel> svc addr <addr> [ip|mac]
<channel> svc none
Description:
Specify that the VC for a PPP channel should be an SVC (i.e. created by signalling). This can either be by listening for
an incoming call, or by making an outgoing call to a specified ATM address.
The outgoing call or listen occurs immediately. If the call fails it will be retried after a few seconds. In the PPP state
machine, providing a connection of this form causes the channel to be ‘up’ or ‘down’. Note that
enable
must also be
used, to allow the link to become operational. Outgoing and incoming UNI signalling calls are identified by a BLLI
value that identifies PPP. (Aside: A BLLI of length 3 bytes is used, hex values 6B, 78. C0.) If the channel is already
attached to an SVC or PVC then it is closed, and re-opened with the new settings. If it cannot, it remains closed. If a
single argument
none
is supplied, any current connection is torn down. This is equivalent to
pvc none
on the channel.
The
ip
or
mac
indicates which form of data is transported over the connection: one of IP data (controlled by the IPCP
protocol), or MAC data (for BCP). If neither is provided,
ip
is assumed. Providing an SVC setting unsets any PVC
setting. See the
pvc
command.
Configuration saving saves this information. By default a channel has no connection information.
Example:
> ppp 3 svc
47.00.83.01.03.00.00.00.00.00.00.00.00.00.00.20.2b.00.03.0b.00
> ppp 4 svc listen ;listen for incoming call
> ppp 7 svc none ;tear down connection, remove setting
13.7.19. <channel> theylogin
Syntax:
<channel> theylogin pap|chap|none
- 57 -
- Solwise 1
- Setup instructions for 3
- Solwise SAR703 ADSL Router 3
- 1. Introduction 7
- 2. Getting Started 8
- 2.2. Configuration Software 9
- 4. Client TCP Setup 12
- 5. Testing 14
- 6. Port Forwading 15
- 7. Advanced PPP Settings 16
- 8. Firmware Upgrade 17
- Stop Bits :1 18
- Flow Control :None 18
- BPS :9600 18
- Data bits :8 18
- Parity :None 18
- 10. CLI Configuration 20
- Ethernet 21
- > ip nat add ppp_device ↵ 22
- 11.3. SNMP 25
- 13.2.2. help 28
- 13.2.3. (history mechanism) 28
- 13.3.4. isfs rm 30
- 13.3.5. flashfs update 30
- 13.4.1. device add 30
- 13.4.2. device delete 30
- 13.4.3. device list 31
- 13.4.4. ethertype 31
- 13.4.5. filter 31
- 13.4.6. filterage 32
- 13.4.7. flush 32
- 13.4.8. portfilter 32
- 13.4.9. status 32
- 13.4.12. spanning hellotime 33
- 13.4.13. spanning maxage 34
- 13.4.18. spanning priority 35
- 13.4.19. spanning status 35
- 13.5.1. arp 36
- 13.5.2. config 36
- 13.5.3. device 37
- 13.5.4. disable 39
- 13.5.5. enable 39
- 13.5.6. get 40
- 13.5.7. ipatm abort 40
- 13.5.8. ipatm arp 40
- 13.5.9. ipatm arpserver 40
- 13.5.10. ipatm files 41
- 13.5.11. ipatm lifetime 41
- 13.5.12. ipatm pvc 41
- 13.5.13. iphostname 42
- 13.5.14. norelay 42
- 13.5.15. ping 43
- 13.5.16. portname 43
- 13.5.17. relay 44
- 13.5.18. rip accept 45
- 13.5.19. rip allowed 45
- 13.5.20. rip boot 45
- 13.5.21. rip hostroutes 46
- 13.5.22. rip killrelay 46
- 13.5.23. rip poison 46
- 13.5.24. rip relay 46
- 13.5.25. rip relays 47
- 13.5.26. rip send 47
- 13.5.27. route 47
- 13.5.28. routeflush 48
- 13.5.29. routes 49
- 13.5.30. stats 49
- 13.5.31. subnet 49
- 13.6.1. ip nat 50
- 13.6.2. nat interfaces 50
- 13.6.3. nat inbound 50
- 13.6.4. nat info 51
- 13.6.5. nat protocol 52
- 13.6.6. nat sessions 52
- 13.6.7. nat stats 52
- Channels 53
- Interfaces 53
- Interface 1 and Channel 1 53
- 13.7.14. <channel> llc 56
- 13.7.15. <channel> pvc 56
- 13.7.16. <channel> qos 56
- 13.7.18. <channel> svc 57
- 13.7.21. bcp 58
- 13.7.24. user 59
- 13.8.1. access 59
- 13.8.2. config 60
- 13.8.3. trap 60
- 13.9.1. show rate 60
- 13.9.2. show defect 60
- 13.9.10. up 62
- 13.9.11. show id 62
- 15.1. Power Adapter 63
- 17. Appendix C Glossary 65
- European CTR 21 compliance 69
Prodotti e manuali riguardandi Networking Asus AAM6000EV
Networking Asus AAM6010EV-T4 Manuale Utente
(38 pagine)
(38 pagine)
Networking Asus M2NBP-VM-CSM Manuale Utente
(38 pagine)
(38 pagine)
Networking Asus eMTA Informazioni Techniche
(53 pagine)
(53 pagine)
Networking Asus RT-N10E Manuale Utente
(46 pagine)
(46 pagine)
Networking Asus AAM6000EV Manuale
(17 pagine)
(17 pagine)
Networking Asus P4B Manuale Utente
(122 pagine)
(122 pagine)
Networking Asus RT-AC68R Manuale Utente
(70 pagine)
(70 pagine)
Networking Asus P4B Manuale Utente
(32 pagine)
(32 pagine)
(92 pagine)
Networking Asus GIGAX2048 Manuale Utente
(115 pagine)
(115 pagine)
Networking Asus RT-N15U Manuale Utente
(60 pagine)
(60 pagine)
Networking Asus RT-N12 Manuale Utente
(53 pagine)
(53 pagine)
(120 pagine)
Networking Asus WL-100G Manuale Utente
(91 pagine)
(91 pagine)
Networking Asus WL-100G Manuale Utente
(57 pagine)
(57 pagine)
YORKVILLE Acustica manuali utente
La lista di YORKVILLE Acustica prodotti contiene 66 manuali utenti per 53 modelli. Tutte le guide utenti pdf sono disponibili per essere scaricate o visionate online.
| Modelli | Tipo di Documento |
|---|---|
| C120P | |
| C170P | |
| C1890 | |
| C2285 | |
| C2560 | |
| C2891 | |
| CA1T | |
| CM1260 | |
| E10 | |
| E10P | |
| E1152 | |
| E12 | |
| E15 | |
| E152 | |
| E215 | |
| E2152 | |
| EF500P | |
| EX1 | |
| EX2 | |
| FH1W | |
| FH2W | |
| LS2100P | |
| LT-70V | |
| M1610-2 | |
| MC12D | |
| MM5D | |
| NX10C | |
| NX200S | |
| NX25P-2 | |
| NX300-2 | |
| NX300P | |
| NX35-2 | |
| NX55P-2 | |
| NX720S | |
| NX750P-2 | |
| PGM8 | |
| PowerMAX22-2 | |
| PS15P | |
| PSA1 | |
| PSA1S | |
| PSA2S | |
| TX8 | |
| TX9S | |
| U15P | |
| UCS1P | |
| YSM5 | |
| YSM8 | |
| YSS10 | |
| YX15PC |
© 2020, manymanuals.it. Tutti i diritti riservati | 0.042 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale